home *** CD-ROM | disk | FTP | other *** search
/ Tech Arsenal 1 / Tech Arsenal (Arsenal Computer).ISO / tek-20 / radiomd2.zip / R7000.11 < prev    next >
Text File  |  1991-03-10  |  2KB  |  38 lines

  1. R7000.11
  2.  
  3. Subject: Double the number of memory channels in the ICOM R-7000!
  4.  
  5.   Increasing the number of memory channels in the R-7000 is fairly
  6. easy.  The modification can be made in about an hour.  The high
  7. order address bit (A10) of the memory chip is tied to ground.  You
  8. need to lift that pin from ground and install a switch to toggle
  9. this pin to ground or +5 volts.  That will give you two different
  10. banks of memory channels.  The original bank when the switch is on
  11. ground, and an additional bank when the switch is on +5 volts.
  12.  
  13.   Before you start the modification, write down the frequencies that
  14. you have programmed into the unit.  During the modification you
  15. will be unsoldering one lead of the Lithium backup battery.
  16.  
  17.   The ICOM R-7000 uses only part of the memory on it's Static Ram
  18. chip.  You can access the the unused portion of this memory thereby
  19. doubling the number of memory channels.
  20.  
  21.   The memory chip is IC-8 located on the Control Board.  The control
  22. board is on the bottom of the rig under the mounting location for
  23. the voice synthesizer and remote control boards.  It can be accessed
  24. by removing the four philips head screws on the metal partition.
  25.  
  26.   IC-8 is under the Lithium battery.  With the rig upside down and
  27. the back of the rig toward you, unsolder the left lead on the Lithium
  28. battery and tilt it up out of your way.
  29.  
  30.   Remove the six mounting screws for the control unit PC board and
  31. the three connectors along the edge of the board closest to you.
  32. This will allow you to tilt the board up and get to bottom of the
  33. board.  Unsolder IC-8 pin 19 (address bit A10).  Then go to the top
  34. of the board and "gently" pull this pin through the board.  Connect
  35. a 47k resistor from this pin to a source of +5 volts.  You can find
  36. +5v on pin 14 of any of the 14 pin chips to the left of IC-8.
  37. CONTINUED IN R7000.12
  38.